Circle+Radius command often auto-sizes the radius to 1 unit.

classic Classic list List threaded Threaded
3 messages Options
Reply | Threaded
Open this post in threaded view
|

Circle+Radius command often auto-sizes the radius to 1 unit.

eljayel
When using the mouse, if 'Circle+Radius' is selected, the prompt 'Specify circle centre' is displayed, but if a point is selected Librecad draws a circle of radius 1 and displays 'Specify circle centre' again.
Sometimes similar behaviour happens when drawing a line segment between two points, but I haven't seen anything similar with any other commands (although I haven't been using LibreCad for very long).
If the command-line is used, the command completes successfully.
This happens with quite a few different versions, but particularly 2.1.3 in Windows 10, and 2.1.2 in Ubuntu.
Reply | Threaded
Open this post in threaded view
|

Re: Circle+Radius command often auto-sizes the radius to 1 unit.

dellus
Look at the tool options bar. With many tools you can or have to make settings there. The contents change according to the tool.

Reply | Threaded
Open this post in threaded view
|

Re: Circle+Radius command often auto-sizes the radius to 1 unit.

eljayel

Thankyou - I was only watching the command line!


On 21-Oct-18 9:01 PM, dellus [via LibreCAD] wrote:
Look at the tool options bar. With many tools you can or have to make settings there. The contents change according to the tool.




If you reply to this email, your message will be added to the discussion below:
http://forum.librecad.org/Circle-Radius-command-often-auto-sizes-the-radius-to-1-unit-tp5716559p5716560.html
To unsubscribe from Circle+Radius command often auto-sizes the radius to 1 unit., click here.
NAML