Dimensions are not correctly displayed for 10, 20, 30, etc.

classic Classic list List threaded Threaded
3 messages Options
Reply | Threaded
Open this post in threaded view
|

Dimensions are not correctly displayed for 10, 20, 30, etc.

Csányi Pál
Hi,

Dimensions are not correctly displayed for 10, 20, 30, etc., when there are zero-end digits out there.

I am using on Debian GNU/Linux the LibreCAD version 2.1.2.

The dimensions, when those are like 10, 20, 30, etc. are shown like 1, 2, 3, etc. There are missing zeroes. They should be displayed like 10, 20, 30, etc.

But when they are like 11, 21, 31, etc., they are shown like 11, 21, 31, etc. Why?
Best, Paul
Reply | Threaded
Open this post in threaded view
|

Re: Dimensions are not correctly displayed for 10, 20, 30, etc.

dellus
I suppose this concerns only digits after the decimal separator: in Options - Current Drawing Preferences - Dimensions - Format units - Linear zeros untick "remove right".
Reply | Threaded
Open this post in threaded view
|

Re: Dimensions are not correctly displayed for 10, 20, 30, etc.

Csányi Pál
dellus wrote
I suppose this concerns only digits after the decimal separator: in Options - Current Drawing Preferences - Dimensions - Format units - Linear zeros untick "remove right".
This setup solve the problem:
Options - Current Drawing Preferences - Dimensions - Format units - Linear zeros untick "remove right"
Thank you very much!
Best, Paul