[OT]Between GPL v3 and GPL v3+

Previous Topic Next Topic
 
classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

[OT]Between GPL v3 and GPL v3+

Borneq
I want write code under licence GPL v3. I am afraid licence "GPL v3 and above" because today is not this licences and I don't know its will be well protect. On the other hand version 4 will be even better than version 3.
what should I write?
  This program is free software, licensed under the terms of the GNU      
  General Public License as published by the Free Software Foundation,    
  version 3 of the License, today is not version 3 or any later version
  but is reserved to change to later version if it release
?
Reply | Threaded
Open this post in threaded view
|

Re: [OT]Between GPL v3 and GPL v3+

R. van Twisk
Administrator

On Jan 27, 2012, at 6:10 AM, Borneq [via LibreCAD] wrote:

I want write code under licence GPL v3. I am afraid licence "GPL v3 and above" because today is not this licences and I don't know its will be well protect. On the other hand version 4 will be even better than version 3.
what should I write?
  This program is free software, licensed under the terms of the GNU      
  General Public License as published by the Free Software Foundation,    
  version 3 of the License, today is not version 3 or any later version
  but is reserved to change to later version if it release
?


Since you are asking on the LibreCAD list, all software our developers are writing for LibreCAD are GPLv2+.




If you reply to this email, your message will be added to the discussion below:
http://librecad.1049103.n5.nabble.com/OT-Between-GPL-v3-and-GPL-v3-tp5435096p5435096.html
To start a new topic under LibreCAD, email [hidden email]
To unsubscribe from LibreCAD, click here.
NAML