I'm attempting to print a part drawing at a set scale to be used as a layout. The parts are being drawn at 1:1 scale, then blown up using the scaling in print preview to 62.5:1 scale. To attempt to get to the bottom of the issue, I drew a rectangle the was .112"x.112" which should be 7"x7" at 62.5:1 scale. After printing, I measured the layout and the scaling is correct on the y-axis, but the x axis is at 7.070".
I double checked the printers settings to make sure that it wasn't using any additional resizing on the document, but it isn't. I'm at a loss at what can be done to get this drawing to scale properly. Any thoughts or input would be greatly appreciated!