Have been using LibreCad with no problems for years with no problems. I recommended it to many. I recently upgraded to Ubuntu 19 now I am unable to create more than one line in the 2 point. After I draw the first line no matter the angle, I am unable to extend to form a second line. Am I overlooking something in my setup? I have removed and reinstalled LibreCad only to experience the same problem. I have tried on my older drawings but same problem. It works on circles ant etc but not 2 point lines.
Re: Unable to create more than 1 each 2 point line.
Cleared defaults and cleared problem. Was the problem created
when I updated to Ubuntu 19? Thanks a million, I was building
something, I need the LibreCad to proof my design. Have spent
five hrs in garage uncovering errors in my hand drawings with no
concrete solution. Now I can analyze it.
On 4/9/20 2:53 PM, dellus [via
Does Options - Application Preferences - Defaults - Clear Settings
- All help?
If you reply to this email, your
message will be added to the discussion below: