Posted by ACL on May 16, 2020; 5:29pm
URL: https://forum.librecad.org/Spacebar-as-Enter-tp5718083p5718869.html

Funny, reading through the documentation it sounds like space as enter is a done deal a long time ago, but it sure doesn't work for me on Mac.

From https://librecad.readthedocs.io/en/latest/guides/cmdline.html

Start typing any command, e.g. li, rect, etc. and then [Enter] or the [Space bar].
Press the [Space bar], type any command and then [Enter] or the [Space bar].
Press [Ctrl + M], any command and then [Enter] or the [Space bar].
Press [Shift], any command and then [Enter] or the [Space bar].
Press [F1], any command and then [Enter] or the [Space bar].
With the Keycode Mode on, type a two letter command, e.g. li, ci. Pressing [Enter] is not required.

So what gives? Did this get taken out again?

EDIT: OK, I see that even though I just downloaded it, it's an older release: 2.1.3 from 2016. Seems to be the latest DMG. I guess I have to figure out how to compile 2.2.0.