Circle Trim problem

Circle_Trim_problem.dxf
Dear Peoples; - I've spent way too long with this problem! - I've perused your forum and trolled thru numerous web links & YouTube vids...
Please can someone respond with (idiot proof) instruction as to how I may resolve; -
The attached file is a floorplan.
The green circle to be "trimmed" so as to describe the arc of an inward opening door,
the two green radii representing door closed (horizontal) & open (obtuse).
The blue line is solely a "construction" in my efforts to effect resolution...

So please; - how does one TRIM the lower & larger ARC to the orthogonal walls?

Sincere thanks in advance,
Bebbspoke (aka John)

Working on a circle with the trim command can be confusing, and not working in the way we wish. At certain constellations it might work, at others it doesn't. A circle has a running direction, from 0 degrees (right quadrant) counterclockwise.
It's generally easier to cut it up with Divide at the desired points and delete the unwanted part.
Or draw the arc from the onset with Curve - Center, Point, Angles.

Working on a circle with the trim command can be confusing, and not working in the way we wish. At certain constellations it might work, at others it doesn't. A circle has a running direction, from 0 degrees (left quadrant) counterclockwise.

It's generally easier to cut it up with Divide at the desired points and delete the unwanted part.

Or draw the arc from the onset with Curve - Center, Point, Angles.

---

If you reply to this email, your message will be added to the discussion below:

https://forum.librecad.org/Circle-Trim-problem-tp5719088p5719089.html

To unsubscribe from Circle Trim problem, click here.

NAML