I want to hatch an enclosed area that is a series of polylines.
It doesn't happen and LibreCAD (version 2.1.3) tells me the area is not enclosed.
Using 2 points and snap intersection I check every intersection and every one of them are definitely connected. I've even tightly zoomed each intersection and verified the same result visually.
Any thoughts are appreciated.
I am using version 2.1.3, and hatching works ok for me. I have attached a snapshot of a quick test hatch. It is simply a couple of nested polyline rectangles. I selected both entities, and then put in the hatch.
Hope this works for you.