LC doesn't ask for angle or radius

On Jul 5, 2016, at 4:19 PM, humulus [via LibreCAD] <[hidden email]> wrote:

Hi all,

I'm using LC 2.1.1 on Windows 7.

When I draw a line via "angle" I expect to be asked for the angle. It always draws a line 45 degrees.

When I draw a circle via "center,radius" I expect to be asked for the radius. It always draws a circle with radius 1.
The same goes for "2 points, radius". LC always tells me "radius=1 is too small for points selected".

Am I doing something wrong or is it a bug?

regards,
Ruud

---

If you reply to this email, your message will be added to the discussion below:

http://forum.librecad.org/LC-doesn-t-ask-for-angle-or-radius-tp5714036.html

To start a new topic under LibreCAD-user, email [hidden email]
To unsubscribe from LibreCAD, click here.
NAML