LibreCAD - Re: Drawing Scale ratio:

Re: Drawing Scale ratio:

Posted by R. van Twisk on Jul 07, 2011; 12:15pm
URL: https://forum.librecad.org/Drawing-Scale-ratio-tp4560387p4560861.html

Frans,

I don't believe it's needed to reset any scaling after printing,

so that means 'everything should be within the drawing 1:1',

1KM measure stays 1km measure, no matter what the printing scale was.

if you think this is a bug, it's best reported on sf.net here: https://sourceforge.net/tracker/?limit=25&func=&group_id=342582&atid=1433844&assignee=&status=&category=&artgroup=&keyword=&submitter=&artifact_id=&assignee=&status=1&category=&artgroup=&submitter

I am planning to starft this weekend to work on bug fixes that where recently reported

for a RC2.

Ries

On Jul 7, 2011, at 5:24 AM, Frans [via LibreCAD] wrote:

OK, I figured it out and managed to print. Interesting and practical way of doing it. Just undo the scaling after printing if you want to work further on the drawing.

If you reply to this email, your message will be added to the discussion below:
http://librecad.1049103.n5.nabble.com/Drawing-Scale-ratio-tp4560387p4560608.html

To start a new topic under LibreCAD, email [hidden email]
To unsubscribe from LibreCAD, click here.