https://forum.librecad.org/Streamlining-and-Updating-Blocks-tp5529085p5530116.html
Will do Claude, sorry if I jumped the gun. My thinking re: default base point is that unless the user is specifically creating a block in a "block editor" (not as part of q drawing) then there won't be a relation 0,0 and the desired base point. In my own use of the software that's always coming back to bite me and then I have to edit block attributes, locate the block in the window (usually it's nowhere near 0,0) then reposition it. If there's another way to change the base point in the "block editor" (ie, after the initial block creation) then I haven't found it yet.
Anyway, I'll post my ideas as individual feature requests over at source forge.
>
>
>
> Hello Joseph,
>
>
>
> >
>
> > Changes I'm Proposing:
>
> >
>
> > ...
>
> >
>
> > 2. I want to create an "Insertion Point" tool for use in the
>
> > block editor rather than defaulting the insertion point to 0,0
>
> >
>
>
> - Personally, I prefer the default insertion point being at (0,0),
>
> because this is simple and fast.
>
>
>
> - I suggest you to put your proposal as feature requests
>
> in LibreCAD Feature Requests Tracker, at the following
>
> place:
>
>
> http://sourceforge.net/tracker/?group_id=342582&atid=1433847
>
> Once done, this proposal can be reviewed by LibreCAD
>
> development team.
>
>
>
> - For the bugs, use the LibreCAD Bugs Tracker below:
>
>
> http://sourceforge.net/tracker/?group_id=342582&atid=1433844
>
>
> From a LibreCAD contributor,
>
>
> Claude
>
>
>
>
>
>
>
>
>
>
>
>
> If you reply to this email, your message will be added to the discussion below:
>
> http://forum.librecad.org/Streamlining-and-Updating-Blocks-tp5529085p5529902.html
>
>
>
> To start a new topic under LibreCAD-dev, email
[hidden email] >
> To unsubscribe from LibreCAD-dev, click here.
>
> NAML
>
>