Re: Mapper
Posted by R. van Twisk on May 01, 2012; 1:26am
URL: https://forum.librecad.org/Mapper-tp5648450p5677280.html
I could download the files now, my Russion isn't what is was…
URL: https://forum.librecad.org/Mapper-tp5648450p5677280.html
I could download the files now, my Russion isn't what is was…
Apparently in LibreCAD 2.0.x there has been something changed
when it comes to printing.
In LibreCAD 1.0.1 this works fine. I do admit printing is not the best
think in LibreCAD, but the PDF looked correct.
The below image is a screenshot when I used export to PDF in OSX.
On Apr 30, 2012, at 6:42 PM, feugeniy [via LibreCAD] wrote:
About using PDFCreator:
Mostly of polygonal and straight lines exported to PDF well. But if it are curves (ellipses or cycles) in drawing then results - curves are TREMBLING in PDF.
See my test-results bellow:
http://upwap.ru/2226610
If you reply to this email, your message will be added to the discussion below:http://forum.librecad.org/Mapper-tp5648450p5677197.htmlTo start a new topic under LibreCAD, email [hidden email]
To unsubscribe from LibreCAD, click here.
NAML
| Free forum by Nabble | Edit this page |