Hi,
I planned hyperbola, parabola support. I still want both for 2.0.
Looks like we still need to clean up the painter for 2.0
Because I am also getting busy recently and Ries is designing 3.0 framework, we may want to end the alpha phase of 2.0 after the conic sections and painter fixes.
thanks,
dongxu
Is there any word on when 2.0 is going to come out? I have been lurking a bit but haven't really done anything more on the manual because I am not sure what would need to change for 2.0. There is some other stuff that I can work on but I just need to dive into it.
On a personal note, I had a new baby girl and that has zapped up some of my time. Life is slowly starting to turn back to normal.
Any information on 2.0 would be greatly appreciated.
Thanks!
Caleb.
If you reply to this email, your message will be added to the discussion below:http://forum.librecad.org/Introduction-tp5520851p5679811.htmlTo start a new topic under LibreCAD-dev, email [hidden email]
To unsubscribe from LibreCAD-dev, click here.
NAML
| Free forum by Nabble | Edit this page |