Posted by sp1der on May 09, 2013; 2:38pm
URL: https://forum.librecad.org/Relative-Zero-Point-tp5708013p5708040.html

pwright2 wrote

I hope that Bob follows these threads since I think that your answer would make a useful addition to his LC user manual.

Yes Bobs work is so useful, thanks for the kind words Paul.

pwright2 wrote

the final point was off to the right of the viewable edge of the screen.  I presumed I could use the window scrollbar to pan to see the final point but I could not.  I had to zoom in to make the whole drawing small enough that the final point showed in the window.  Is that normal for LC or is there something wrong with my setup?

Quite normal behavior, the easiest thing to do is type za (Autozoom) and hit the enter key this will zoom your drawing to its full extents - or click on the Auto zoom option, which will do the same job.

Hopefully in time we can have some new features added, like the ability to save a particular view  - so that it can be returned to time and time again if needed.