Posted by sun.go on Nov 04, 2013; 5:03pm
URL: https://forum.librecad.org/Cut-a-part-between-2-elements-tp5709121.html

Hallo,

I was using MegaCad before i found librecad.

I miss a good tool, who increase the workflow a lot.

In Megacad it was possible to cut a line or an element not only on one position, also between 2 next elements.

If there are 2 lines, who cross my element i want to trimm or cut, so i only make one click and the element is cut between the lines. In librecad i have to cut both sides in 2 steps (select/cut and deselect) and then cut in 2 steps. This are 6 steps for the same i was unsing one click in Megacad.

I design Stalions and fences made from steel. There are a lot of metal, who crosses each other .... a lot to cut und trimm ...

Can You please include this function, or is there such a function?

Andres