Posted by peasthope on Nov 07, 2013; 5:20pm
URL: https://forum.librecad.org/The-snap-grid-tp5709126p5709133.html

dxli wrote

... grid is set to by a number 10, based on the current zooming. Setting units gives the number 10 units:

Setting units to mm, means the grid is currently by 10mm. When setting units to inch, it means the grid is currently by 10 inch.

Thanks for explaining. In other words, (grid interval) = (zooming scale) x (unit of measure)?  Geometry of the object being drawn is constrained by a characteristic of LibreCAD rather than by the requirement of the designer.  This is a temporary implementation during software development?  

Regards,           ... Peter E.