Posted by AussieModelEngr on Feb 20, 2014; 4:26am
URL: https://forum.librecad.org/How-to-fill-Paint-an-area-tp5709605p5709616.html

Hello arct and thank you for replying but I have not been very successful.

After quite a bit of experimenting it appears that the area that is to be coloured, even though it is enclosed by lines, it must not have any lines extending beyond the enclosed area which means I need another layer and draw the lines from intersection to intersection so that no lines extend beyond the area to be enclosed.

Before I spend a lot of time doing above, can you please confirm that there is not an easier way of doing this?