Posted by jmweaver41 on Apr 16, 2014; 9:41pm
URL: https://forum.librecad.org/Retroceder-Re-Circle-2-points-and-radius-tp5709816p5709817.html

Normally I use the perpendicular lines trick, and draw a circle tangent to those - my problem is that my circle isn't crossing at 90 degrees relative to the lines.  Basically its a triangle, I have the circle intersecting near a corner, so the center point is somewhere below and to the side.  I know the two points it will intersect the triangle at, and the radius of the arc between.



I think the command line version will work for me, I already know that I should be using it a lot more to simplify things, I just need to figure out the syntax and see if I can remember some of the math involved.  

Thanks for the help, I'll try it out now!