Posted by Quenzo on Oct 20, 2014; 4:58pm
URL: https://forum.librecad.org/preparation-for-2-0-6-any-blocker-tp5710555p5710560.html

Hi. In advance, some of these issues can be my mistakes, in this case I 'm sorry.

Modify--> Trim / Extend two option

1 The cut between two figures curves (circle, ellipse, or arc) is made according to where on each figure is selected. It can cut two, cut one (especially if it's between the ellipse and the circle cutting the ellipse like with the normal cutting option), and may also extend a figure (especially arcs) when you expected to be cut.
It seems that the application sometimes isn't sure lengthen or trim the curves, and if it has to cut one or two.
However, with the straight lines have no problem.

2 When you try to cut a circle or ellipse intersecting a closed polyline or a freehand line if you select these first, the application breaks and closes.



Draw--> Circle--> tangential 2points option

This option does not work as I expected. I wanted to draw a circle (green) tangential to the small white circle and then going through two points, the left upper and lower corners on the square, but the application draws the red circle. Indeed the two circles meet the two conditions (being tangential and passing through two points), but the application always draws the red circle. I don't know if this is a bug or can be configured differently to make the green circle.

Best regards

Manel