Posted by eslavko on Nov 05, 2014; 7:38pm
URL: https://forum.librecad.org/Rounding-tp5710609p5710613.html

I have no trouble on rounding:
round.dxf

Are you running the latest release (2.0.6)?

---

If you reply to this email, your message will be added to the discussion below:

http://forum.librecad.org/Rounding-tp5710609p5710611.html

To start a new topic under LibreCAD-user, email [hidden email]
To unsubscribe from Rounding, click here.
NAML

Actualy rounding works but trimming not. If I uncheck Trim (checkbox near Radius entry) then I got added radius and existing lines untact. But If I check Trim then lines are trimmed in wrong side. I just check if I apply radius (without trim) and then trim manualy. And manual trim doesn't work either. (it cut wrong side). So problem is not in "Roun" but in "Trim".
Slavko.