Posted by Quenzo on Nov 16, 2014; 6:20pm
URL: https://forum.librecad.org/Commands-tp5710691.html

Hi to everyone

 Four issues:

1) There are some command shortcuts that do not work well, or just do not work. Apparently, this is due to they are redundant. Then I do a proposal for each of them. (the commands are written between 'apostrophe' and actions between "quotes"):


'a'   "angle", "arc"
proposals:
'a' to "arc"
'an' to "angle"


'c'   "columns", "close", "center"
proposals:
'c' to "close"
'ce' to "center"
'co' to "columns"


'l'   "length", "line"
proposals:
'l' to "line"
'le' to "length"


'r'   "radius" "reverse" "redo"
proposals:
'r' to "redo"
'ra' to "radius"
'rev' to "reverse" (already there 're' to "reverse direction")

Another redundancy: When I write 'cl' in the command line, the application takes the action "linear dimension", but for this exists yet: 'dr'.



2) This is a question:
It is possible that the command 'angle' work with polyline arc?




3) The option "Command Language" (Edit -> Application Preferences ...--> Appearance tab), does not take action. The commands, always work only in the language set by the option: "GUI Language".




4) There is a redundancy in the menu "Draw". On the one hand exists Draw-->Line-->Polyline, but it already exists on the other hand, in the group of specific options to draw polylines: Draw-->Polyline-->Polyline, which allows the same functions.
I think that should be removed the option: Draw-->Line-->Polyline.

Regards
Manel