Chet

1. Draw a circle and two rectangles.

2. Explode the rectangles into lines.

3. Turn on the intersection snap and use the Divide command to split the circle and lines where they cross.

4. Delete the unwanted parts of the circle and lines.

Mike

---

If you reply to this email, your message will be added to the discussion below:

http://forum.librecad.org/Cutting-a-section-out-of-a-circle-designing-a-robot-tp5712687p5712688.html

To unsubscribe from Cutting a section out of a circle (designing a robot), click here.
NAML