Re: Trying to use Fillet but don't see Radius
Posted by rfresh737 on
URL: https://forum.librecad.org/Trying-to-use-Fillet-but-don-t-see-Radius-tp5712926p5712929.html
Yes I see the Radius Tab now.
However, it seems awkward to know what to do with the mouse over a 90 degree corner? I click once and see the arc but then the command window prompt says "Specify Second Entity" ?
One time I clicked once to get the arc to appear and then clicked again and it set it correctly into the upper left corner but I can't do that again with the other corner. No matter where I click or how I move the mouse I can't finish the task. Also, as I move the mouse around the arc changes, not a bad thing but I don't know what to do to 'sett' the arc when I have it in the correct orientation.
There must be a correct sequence of steps to do this correctly or is just isn't going to work and that sequence isn't an obvious one.
URL: https://forum.librecad.org/Trying-to-use-Fillet-but-don-t-see-Radius-tp5712926p5712929.html
Yes I see the Radius Tab now.
However, it seems awkward to know what to do with the mouse over a 90 degree corner? I click once and see the arc but then the command window prompt says "Specify Second Entity" ?
One time I clicked once to get the arc to appear and then clicked again and it set it correctly into the upper left corner but I can't do that again with the other corner. No matter where I click or how I move the mouse I can't finish the task. Also, as I move the mouse around the arc changes, not a bad thing but I don't know what to do to 'sett' the arc when I have it in the correct orientation.
There must be a correct sequence of steps to do this correctly or is just isn't going to work and that sequence isn't an obvious one.
| Free forum by Nabble | Edit this page |