Posted by Chetv on
URL: https://forum.librecad.org/Printing-out-drawing-tp5713811.html

I have made a relatively simple drawing with an outer circle of 7.50". Have set paper to letter, landscape. When I go to print drawing it comes out extremely small on the paper. In print preview I see a very small picture of my drawing and separately a small which rectangle (i assume the paper). Scale is 1:1. General scale = 1

I get this message in the command line

Loaded document: C:\Users\Chet\f30 strut bracket.dxf
Warning:: Paper size less than 10mm. Paper is too small for fitting to page
Please set paper size by Menu: Edit->Current Drawing Preferences->Paper
RS_ActionPrintPreview::fit(): Invalid paper size
Warning:: Paper size less than 10mm. Paper is too small for fitting to page
Please set paper size by Menu: Edit->Current Drawing Preferences->Paper
RS_ActionPrintPreview::fit(): Invalid paper size
Warning:: Paper size less than 10mm. Paper is too small for fitting to page
Please set paper size by Menu: Edit->Current Drawing Preferences->Paper
RS_ActionPrintPreview::fit(): Invalid paper size

Any yet when I go into the current drawing preferences Letter size is selected 11X8.5

I can't find what I'm doing wrong?

Please make some suggestions to correct this situation.

Regards,
Chet