Posted by Chetv on
URL: https://forum.librecad.org/Printing-out-drawing-tp5713811p5713820.html

I didn't find anything but I think this is the cause. When I drew the 3"+ circles they were very small and I had to blow them up to work on them. Now when you print them they return to there original small size!

I think the initial scale of the drawing was too large. How do you set this?

I want the drawing to be on a letter size A 8.5x11 Then my drawing should be visible without excessive zooming in.

How does zooming in effect the printing size?