Posted by lectrond on Jun 21, 2017; 2:13pm
URL: https://forum.librecad.org/Drawing-Line-width-different-than-printed-width-tp5714995.html

I just started using LibreCad after years of Autocad.  And my first problem is a major one.  In order to get a line that can be seen when printed, I have to increase the line width on the drawing until my circles look like donuts.  The ratio between the drawing and the print preview is significant.  I have so far not found how to correct this.  Also, I have no Block list or Layer list on my right hand side and I can find no way to bring them up.  It is difficult to make accurate drawings with all these fat lines.  There must something going on.  I checked blogs and it seems that everyone tells me to increase my line thickness.  How about a clear and simple solution so I can start drawing again.