LibreCAD - Re: Drawing Line width different than printed width

Re: Drawing Line width different than printed width

Posted by lectrond on Jun 30, 2017; 2:49pm
URL: https://forum.librecad.org/Drawing-Line-width-different-than-printed-width-tp5714995p5715020.html

When I draw them to the width I want printed, they are very wide in drawing mode. Is this correct. Are they different. Oh forget it, I have a new problem. I pulled up my Library Browser, located an electrical symbol folder and opened it. I chose a symbol and tried to drag it into my drawing and only got a red circle with the slash though it. Is Drag and Drop available from the Library Browser to the Drawing?

On Fri, Jun 30, 2017 at 9:19 AM, lectrond [via LibreCAD] <[hidden email]> wrote:

When you go to print preview, does your drawing change? Do your lines become thinner and fainter?

If you reply to this email, your message will be added to the discussion below:
http://forum.librecad.org/Drawing-Line-width-different-than-printed-width-tp5714995p5715019.html

To unsubscribe from Drawing Line width different than printed width, click here.
NAML