LibreCAD - Re: Hatching always failed (working with ellipse and line)

Re: Hatching always failed (working with ellipse and line)

Posted by LordOfBikes on May 19, 2018; 8:13am
URL: https://forum.librecad.org/Hatching-always-failed-working-with-ellipse-and-line-tp5716011p5716013.html

Hello sunggus,

this may happen because of rounding errors with the ellipse.
You can try to use "Trim two" command from "Modify" tools to close the gap.
Or construct and trim the ellipses first and then draw the lines with the mouse using appropriate snap modes.

Hope this helps.

Armin

^{investing less than half an hour into Search function can save hours or days of waiting for a solution}