Posted by Philip on
URL: https://forum.librecad.org/Filleting-problem-tp5716039p5716048.html

Hi Aaron,

I have tried to duplicate your problem but am unable to do so.  In the screenshot below, I created two squares.  Both are 10 x 10 units.  You can see from the command line window that the square on the left was created using the line command.  I used the rectangle tool to draw the one on the right.  I was able to use the fillet tool on both squares without issue.  I am using version 2.1.3.  As LordofBikes says, try to post a screenshot.