Posted by pricemob48 on
URL: https://forum.librecad.org/Re-Re-vertical-lines-tp5715985p5716092.html

Hi All

I am having a similar or same problem.
I am a new user so started working through the user manual from Bob Wolz. The basic exercise was to draw a line from point to point left to right on the x axis, then draw an upward vertical line from the right hand end of that line then a horizontal line to the left then a vertical down to eventually form a box. The first line point to point, left to right on the x axis was fine, however I can't draw the upward vertical line as the cursor will not leave the original x axis.

I have also tried drawing a circle and it will only draw from the original x axis.

I have tried the Lock/Unlock relative zero with no effect.

I am using 2.1.3 on windows 10

Any suggestions would be great.