Posted by sunggus on
URL: https://forum.librecad.org/Confusing-about-Specify-point-on-circle-on-LibreCAD-2-2-0-RC1-tp5716234.html

Hi,

Is anyone can explain what is the meaning of "specify point on circle" as in the picture below? That is occurred when I want to draw a circle. Normally in LC 2.1.3, when I draw line, then I point to one coordinate. Then by command line I enter the radius as asked. But now with LibreCAD 2.2.0 RC1, it is very confusing and I don't know what is the logic behind that change? The LC2.1.3 was correct, it is asked the radius. With this LC 2.2.0 RC1, I have to point somewhere, then I edit the properties to enter the right radius. It make the simple thing become complicated. Really not necessary.

I hope this is corrected in the LC 2.2.0 final release. If not, this is will be a failed release.