Trim Problem
Posted by SupDoc on Oct 06, 2019; 7:28pm
URL: https://forum.librecad.org/Trim-Problem-tp5717786.html
I'm assuming the trim problem has been saved, so I continue. I actually have two problems. 1) When I used fillet, it didn't behave normally. I left this extended line shown. Why did this happen? 2) How do I trim this? I created a helping line, shown crossing the line intended, but trim doesn't seem to do the tick.
URL: https://forum.librecad.org/Trim-Problem-tp5717786.html
I'm assuming the trim problem has been saved, so I continue. I actually have two problems. 1) When I used fillet, it didn't behave normally. I left this extended line shown. Why did this happen? 2) How do I trim this? I created a helping line, shown crossing the line intended, but trim doesn't seem to do the tick.
| Free forum by Nabble | Edit this page |