Posted by MrCAD on May 21, 2020; 5:44pm
URL: https://forum.librecad.org/Trim-commands-drawback-tp5718936.html

Trim commands works perfectly when it comes to bisecting or crossing lines...

But it is not working when it has more than two INTERSECTING curves / line / profile / circle.



What should have been done = If selecting to TRIM line 1,3, and Outer Circle (in actual case, 1,2, and 3 are SINGLE, line) only line 2 should have been TRIM.

What is actually have been done = As per above statement, by selecting circle and line (actually all segments are single), either line 1 or line 3 is deleting, instead of line 2