Posted by dellus on Feb 04, 2021; 10:40pm
URL: https://forum.librecad.org/Can-t-activate-the-command-line-tp5720143p5720144.html

Space bar and Ctrl-M should work. If not you may try with just clicking into it. You get a blinking cursor then.
I sometimes experience it too, that the command line doesn't respond. I don't know what previous actions provoke this. Usually some other actions like clicking into the drawing area or pulling up a selection window solves this.
Or do you think you have to enter the coordinates in the window titled "Command line"? Wrong! This just monitors the last commands.
Below that there is a bar titled "Command:". Here you have to to enter the coordinates, or commands like l or li for line.