Login  Register

Re: Circle Drawing with radius command.

Posted by jww153@gmail.com on Feb 07, 2021; 5:46pm
URL: https://forum.librecad.org/Drawing-Circles-tp5712950p5720161.html

Your response was very helpful when I was working with the circle command.  I have years of experience with AutoCAD and Draftsight.  I expected that executing these commands would be intuitively obvious, but it is not working for me.  You guided me thru using the circle command.  I just tested it again, and it is working as you described.  I am now trying to use the offset command.  I initiate the command and select the line that I want to offset.  How do I move forward from there?  I need to specify which side and the offset distance.  What do I need to do to advance from the selection step?

Thank You,

John Walvoord.

On Fri, Dec 18, 2020 at 5:26 PM John Walvoord <[hidden email]> wrote:
I installed from an internet download.
I am running Windows 10.
It may have been enabled by default, but I have tried to remove some toolbars to free up some screen space, so I may have turned it off not knowing what its function was.


On Fri, Dec 18, 2020 at 4:24 PM LordOfBikes [via LibreCAD] <[hidden email]> wrote:
How did you install LibreCAD?
What is your OS?
Usually the tool option bar should be enabled by default.


If you reply to this email, your message will be added to the discussion below:
https://forum.librecad.org/Drawing-Circles-tp5712950p5719896.html
To unsubscribe from Drawing Circles, click here.
NAML