This could be an already fixed issue. Iirc, it was only with inches, where negative numbers are not accepted.
The workaround was to use 2,0-2.
Or to use an newer LibreCAD version.
I don't remember exact versions or time frame when this issue was active.
It was discussed here in the forum and there is a closed issue on github about it.

---

If you reply to this email, your message will be added to the discussion below:

https://forum.librecad.org/Drawing-Circles-tp5712950p5720191.html

To unsubscribe from Drawing Circles, click here.
NAML