Posted by mikepwagner on Jul 14, 2021; 6:08pm
URL: https://forum.librecad.org/Maybe-a-dumb-question-for-arc-tangential-to-a-line-don-t-you-need-radius-and-degrees-tp5720837.html

I hope that this is not a dumb question - maybe I don’t understand the geometry?

I have been reading the documentation for “Arc Tangential”, and the documentation says that the command takes either a radius or a number of degrees.

Don’t I need both?

Couldn’t I have a 15 degree arc of radius 36” tangential to a line, and also have a 35 degree arc of radius 16 degrees tangential to the same line?