Posted by milwiron on Nov 03, 2021; 5:07pm
URL: https://forum.librecad.org/Open-Contour-tp5721180p5721183.html

I looked and looked, that was it.
When I selected the part with the curser I could hatch it but couldn't with the "select all"  option. That was why. No more open contour for the online quoting.
Thanks again,
Denny

LordOfBikes wrote

There is a small line fragment, 0.0625 long, at X6.25 Y-6.25.

Use Auto Zoom, then usually the drawing is centered in the drawing area.
In this case, the drawing it aligned on top because of the line fragment which is at the bottom right after auto zoom.

After deleting this fragment, it may work.

Armin