Posted by kevin on Jun 14, 2012; 11:07pm
URL: https://forum.librecad.org/new-features-tp5706753p5706768.html

umm ok then   1,2,3,4  was to signafy the degrees  of the line as you lay it out so  you click the lines start point and then say you pull the line perfectly horizontal to the right it should be 0 degrees  and as you   move it up the degrees go up  starting at 1 all the way around to 359 degrees    so you would be moving it up and to the left at the same time till its vertical whitch would be 90 degrees then to the left and down till you are perfectly horizontal  but going left from start you will be at 180 degrees  then as you move down and to the right till you are vertical it will be 270 degrees then as you move right and up till horizontal your back at 0 degrees so the point is to see the exact degrees you are pulling the line at so it should say the exact angel to this tolerance   xxx.xxxx  anywhere between  0 and 360 degrees i dont think i can make this any more clear to you