Posted by squirp on Sep 14, 2012; 9:32pm
URL: https://forum.librecad.org/Lines-went-to-infinity-tp5707037p5707041.html

AHHH! Found the "help layer" - it was checked and unchecking seemed to fix it - Thanks!

If you have time, could you tell me what the purpose of "help layer" is? I must of clicked it by accident.

Paul

Check in your layers if the 'help layer' is checked.

--

Best regards R. van Twisk

Tel. +1 803 426 3350    Skype: r.vantwisk     gtalk:[hidden email]

On Sep 14, 2012, at 3:45 PM, squirp [via LibreCAD] wrote:

On layer Windows all the lines went to infinity, while doing a line parallel to operation on a half inch line. I have the file attached. I tried a refresh and a restart of the application but no improvement. The file is below.

2259-DevonPlace-Kitchen.dxf

Do you see the same thing?

---

If you reply to this email, your message will be added to the discussion below:

http://forum.librecad.org/Lines-went-to-infinity-tp5707037.html

To start a new topic under LibreCAD, email [hidden email]
To unsubscribe from LibreCAD, click here.
NAML

---

If you reply to this email, your message will be added to the discussion below:

http://forum.librecad.org/Lines-went-to-infinity-tp5707037p5707039.html

To unsubscribe from Lines went to infinity., click here.
NAML