Re: LibreCAD for 3D design - problem with hatching
Posted by jluscher on Apr 30, 2014; 12:47am
URL: https://forum.librecad.org/LibreCAD-for-3D-design-problem-with-hatching-tp5709872p5709874.html
URL: https://forum.librecad.org/LibreCAD-for-3D-design-problem-with-hatching-tp5709872p5709874.html
Thanks for the reply!
I look forward to version 3.
Right now I'm stuck because I can't tell how to find any spot
which is NOT "closed" - so that I can "trim" it (or whatever).
I'm attaching the .dxf I am struggling with and would
appreciate it if you could point out how to identify where
I need to make a change to "close" the design.
James
---- www.jluscher.com ----
"Ultimately, our policies in economics are somewhat intuitive and
our models are not accurate enough to tell us what the right policy is..."
-- Robert Shiller, Yale economist, Nobel Prize winner
On Tue, Apr 29, 2014 at 7:39 PM, dxli [via LibreCAD] <[hidden email]> wrote:
we know the current hatching algorithm is not robust, and we would like to create a robust and efficient hatching algorithm in Version 3 of LibreCAD, which is still in early stage of development leading by Ries.
In your case, you can repeat trimming to create a close contour. Please note that “trimming both" is a little buggy.
If you reply to this email, your message will be added to the discussion below:http://forum.librecad.org/LibreCAD-for-3D-design-problem-with-hatching-tp5709872p5709873.html
hexcell_libreCAD_closed.dxf (32K) | Free forum by Nabble | Edit this page |