I can trim with the attached dxf file.

lumo wrote

Hi everyone.

I created a drawing a couple of days ago, and today I was trying to trim some lines to the intersection with other lines.

The problem is that I am not able to select the line to trim. After choosing 'Trim' from the menu, I  "Select limiting entity" and am then asked to "Select entity to trim", which I am unable to do, no matter how many times I try and how close to I zoom.

I tried to create a new drawing, with two new lines. In this setup I am able to trim the lines without any problem.

Any idea on what might be happening to my first drawing? Some configuration issue?

I'm attaching the file, in case anyone is willing to take a look at it.

Thanks and best regards, Luís

Kangoo_Maxi_cima_aberta_v1_simples.dxf

---

If you reply to this email, your message will be added to the discussion below:

http://forum.librecad.org/Triming-lines-tp5712349p5712350.html

To unsubscribe from Triming lines, click here.
NAML