Posted by Ajohn on May 24, 2016; 6:48pm
URL: https://forum.librecad.org/Troublesome-little-red-circle-with-cross-after-a-mistake-tp5713755p5713757.html

No I don't think that is the problem. I've just had another one.

I drew a line across the diameter of the circle using lock to intersection and it did that correctly. I then moved the cursor which started another line which I didn't want so hit escape which did clear the command but left the little red circle.

When it happens like this it doesn't cause any actual drawing problems but may if I need to draw near it again. It just spoils the look as the ref marks usually disappear as soon as the action is over.

I'm wondering if it's  a bug, caused by moving the cursor after completing a line in this case and then escaping to end the command.

John
-