Posted by
vincereynard on
URL: https://forum.librecad.org/3-point-arc-line-tp5715407p5715536.html
Hal,
Many thanks for the reply.
To be honest I haven't tried with either program
for a while.
I prefer Draftsight, (mainly because I know it better probably).
A great advantage to me is (was) that it is easy to paste into a new
drawing.
Then change a drawings colour and place a Mk3 over the top of Mk4.
Differences are then obvious.
Unlike LibreCAD there is no effective help. I just cannot understand why
it simply refuses to work on my W10 machine.
It loads fine, asks (every time) for activation, then vanishes.
Catch 22. It won't work on W10 and my Linux machine is an old 32 bit -
won't work on that either.
I may have to by an old PC, load XP and use an old version!
Regards
Vince
>
>
> G'day vincereynard,
>
> Unless I've misunderstood your request, this may work:-
>
> 1 Set up Mk3 on one layer.
> 2 Have Mk4 on a separate layer within the same drawing.(This may require
> you
> to re-create one of the "Mk's" drawings in the same drawing, for as Dellus
> has noted, you can't cut and paste between drawings) also give each a
> "common" base reference such 0,0 so you can accurately register each.
> Then toggling the layers "Off/on" will allow a comparison between images.
>
> However as you mention your past experience with DraftSight you've
> probably
> thought of this, so please excuse me if I've stated the obvious.
>
> Hal.
>
>
>
>
>
>
>
> _______________________________________________
> If you reply to this email, your message will be added to the discussion
> below:
>
http://forum.librecad.org/3-point-arc-line-tp5715407p5715531.html>
> To unsubscribe from 3 point arc line., visit
>