G'day Nick,

I agree, very silly of DS.

I think I opted out of "3 point arc" for this reply, if not we should stop filling it with "off topic" comments. I hope you can find an answer as I'm very happy with Librecad.

Cheers,

Hal.

Hal,

Apparently the problem with DraftSight is well known.

https://forum.solidworks.com/thread/205261

I've tried some of the solutions but without luck.
Very Silly problem that DS seems not to care about!

Shame.

Regards
Nick

>
>
> G'day Dellus.
>
> Thank you for that, something to remember.
>
> Hal.
>
>
> On 04/12/17 03:47, dellus [via LibreCAD] wrote:
>> You can cut/copy and paste between drawings, but they both have to be
>> opened at the same time.
>>
>> ------------------------------------------------------------------------
>> If you reply to this email, your message will be added to the
>> discussion below:
>> http://forum.librecad.org/3-point-arc-line-tp5715407p5715539.html
>> To unsubscribe from 3 point arc line., click here
>> <
>> NAML
>> <http://forum.librecad.org/template/NamlServlet.jtp?macro=macro_viewer&id=instant_html%21nabble%3Aemail.naml&base=nabble.naml.namespaces.BasicNamespace-nabble.view.web.template.NabbleNamespace-nabble.view.web.template.NodeNamespace&breadcrumbs=notify_subscribers%21nabble%3Aemail.naml-instant_emails%21nabble%3Aemail.naml-send_instant_email%21nabble%3Aemail.naml>
>>
>
>
>
>
>
> _______________________________________________
> If you reply to this email, your message will be added to the discussion
> below:
> http://forum.librecad.org/3-point-arc-line-tp5715407p5715545.html
>
> To unsubscribe from 3 point arc line., visit
>

---

If you reply to this email, your message will be added to the discussion below:

http://forum.librecad.org/3-point-arc-line-tp5715407p5715548.html

To unsubscribe from 3 point arc line., click here.
NAML