LibreCAD - Re: Hatch shows option to fill solid only.No patterns can be selected.

Re: Hatch shows option to fill solid only.No patterns can be selected.

Posted by littlegrey on
URL: https://forum.librecad.org/Hatch-shows-option-to-fill-solid-only-No-patterns-can-be-selected-tp5716119p5716121.html

It wasn't check when I first brought it up. When I checked it, the preview shows it solid. When I uncheck the preview goes away. Patterns do not show as available.

On Thu, Jun 21, 2018 at 12:58 PM dellus [via LibreCAD] <[hidden email]> wrote:

Take tick out of solid fill square, then patterns are enabled.

If you reply to this email, your message will be added to the discussion below:
http://forum.librecad.org/Hatch-shows-option-to-fill-solid-only-No-patterns-can-be-selected-tp5716119p5716120.html

To unsubscribe from Hatch shows option to fill solid only.No patterns can be selected., click here.
NAML